Skip to content
SKU BU-MKH416-BLIMP

Sennheiser MKH416 P48 Condenser Shotgun Microphone with Rode Blimp 2 Wind Shield and Shock Mount System

$1,100.00

Sennheiser MKH416 P48 Condenser Shotgun Microphone with Rode Blimp 2 Wind Shield and Shock Mount System

$1,100.00

Sennheiser MKH416 P48 Condenser Mic Shotgun Microphone TV Film Recording MKH 416

  • Dimensions: Ø 19 x 250 mm
  • Frequency response (microphone): 40.....20000 Hz
  • Sensitivity in free field, no load (1kHz): 25 mV/Pa +- 1 dB
  • Nominal impedance: 25 Ohm
  • Min. terminating impedance: 800 Ohm
  • Equivalent noise level: 13 dB
  • Equivalent noise level weighted as per CCIR 468-3: 24 dB
  • Maximum sound pressure level (passiv): 130 dB
  • Current consumption: 2 mA
  • Voltage: 48 +- 4 V Phantom

Rode Blimp Wind Shield and Shock Mount System

  • Weight: 550gm
  • Dimensions: 285.00mmH x 490.00mmW x 125.00mmD

 

 Manufacturer's Description

Sennheiser MKH416 P48 Condenser Mic Shotgun Microphone TV Film Recording MKH 416

The venerable MKH 416 is a compact pressure-gradient microphone with short interference tube, highly immune to humidity due to its RF condenser design. Featuring high directivity, low self noise, high consonant articulation and feedback rejection, the MKH 416 can handle difficult exterior filming and reporting conditions without any difficulty. Supercardioid/lobe pattern, matte black finish, supplied with the MZW415 windscreen

Features

  • Pressure gradient receiver with short interference tube

  • Hypercardioid at low and medium frequency

  • Above 2kHz approaches lobar pattern

 

Rode Blimp Wind Shield and Shock Mount System

The RØDE Blimp is a complete windshield and shock mounting accessory for the NTG1, NTG2 and NTG3 microphones, as well as any third party shotgun microphone up to 325mm (12 ¾”) in length.

Now featuring the Rycote® Lyre suspension system, the Blimp provides the ultimate in microphone suspension and isolation. Constructed from a single piece of hard-wearing thermoplastic, the Lyre provides superior acoustic suspension to traditional elastic solutions, and will never wear out, sag or snap.

The Blimp’s handle has also been completely redesigned, reducing the product weight significantly, while increasing the ergonomics for handheld use. Housed inside the grip is a heavy-duty Mogami cable which splits via a junction box to a highly-flexible thin cable inside the Blimp, to minimise the transference of vibration to the microphone.

With the lightweight design of the handle and suspension system the new Blimp design is over 25% lighter (550gm without microphone or DeadWombat fitted).

The Blimp attaches to any standard boompole via 3/8" thread attachment at the base. The Universal Blimp Mount is available as an option to remove the handle when the Blimp is being used primarily on a boompole to reduce weight.

The Dead Wombat windshield, caring brush and tail/patch cable are included.

The added confidence of a full ten year warranty* ensures that the Blimp is by far the best microphone windshield system available, further evidenced by a 2009 Red Dot Award and Australian International Design Award for outstanding product design.

*Excludes normal wear and tear of Dead Wombat furry cover or any misuse, modification or improper storage and transportation of the product.